Edge Router Setup

Prior to v5.0, with Neutron, you could set up the gateway in only one way, which was to have a special singleton gateway router called the Provider Router created implicitly when an external network was created in Neutron. The provider router sits at the edge of the cloud and interfaces with the uplink router. The Provider Router is where BGP was typically configured. The biggest limitation of this approach was that it took away the scenario in which you wanted to have an L2 network at the edge instead of a router. Another limitation was that only one such router could exist for the entire cloud.

These limitations are removed in v5.0, where you could design your gateway to be either L2 network or router with as many routers as you wish, all using the Neutron API.

There are two main changes:

Edge Router

The Provider Router is no longer implicitly created upon the external network creation. Instead, the edge gateway routers, called the Edge Routers, are created explicitly using standard Neutron API. With this approach, multiple Edge Routers can be created, and they are optional.

Gateway Virtual Topology

In the previous model, the Provider Router was connected directly to the tenant routers, with the external networks hanging off of the Provider Router.

In the new model, the external networks exist between the edge and the tenant routers.

To create the gateway topology issue the following Neutron commands.

Create a standard neutron router:

neutron router-create <EDGE_ROUTER_NAME>

Attach the edge router to an external network:

neutron router-interface-add <EDGE_ROUTER_ID> <EXT_SUBNET_ID>

Create a special network called uplink network, representing the physical network outside of the cloud:

neutron net-create <UPLINK_NET_NAME> --tenant_id admin --provider:network_type uplink

Create a subnet for the uplink network matching the CIDR used in the uplink network (could just be /30 if linked directly to another router):

neutron subnet-create --tenant_id admin --disable-dhcp --name <UPLINK_SUBNET_NAME> <UPLINK_NET_NAME> <CIDR>

Create a port on the uplink network with a specific IP that you want to use and the binding details so that this virtual port gets bound to a specific NIC on the gateway host:

neutron port-create <UPLINK_NET_ID> --binding:host_id <HOST_NAME> --binding:profile type=dict interface_name=<INTERFACE_NAME> --fixed-ip ip_address=<IP_ADDR>

Attach the uplink port to the Edge Router:

neutron router-interface-add <EDGE_ROUTER_ID> port=<UPLINK_PORT_ID>
Questions? Discuss on Mailing Lists or Chat.
Found an error? Report a bug.


loading table of contents...